Connecting to CCN using a Macintosh
If you're in a hurry...
If you already know how to use your modem and communications software,
here are the communications settings for
connecting to the Chebucto Community Net. For more detailed instructions,
keep reading.
What you need:
- A Macintosh (any model)
- A communications program
- A modem
- An available telephone line
There are many commercial software packages.
Modems are available from any computer retailer. Good quality
14,400 bps modems can be bought for less than $25.; 56k modems for
less than $75.
You can use your current telephone line to connect to the
Chebucto Community Net.
To log on, follow the steps listed under the heading, "Once you are
connected."
Step-by-step connection guide
- Turn off your computer and modem.
- Connect the telephone cord that came with your modem to a telephone
wall jack.
- Connect the serial cable to your Macintosh's modem port - a socket
on the back labeled with a telephone icon.
- Plug the other end of the cable into your modem.
- Plug the modem's power cord into power outlet, and turn the modem on.
- Now, start your Macintosh.
For more detailed instructions, refer to the manual that came with your
modem. If you have a PowerBook, you may have an internal modem (one
installed inside your computer) or an external one. Macintosh AV users
may use the software-based Apple Express modem. If you have this kind of
modem, follow the instructions that came with it.
Installing your software
You can use any communications software, including the communications
modules in multi-function software such as Microsoft Works.
Follow the program's instructions to install the software on your
computer's hard disk drive. If you are using a system with only floppy
drives, make a backup copy of the communications software disk. Put the
original in a safe place, and use the copy. If you have difficulty
copying files or installing the software, consult the manuals that came
with your Macintosh.
How to connect
You will need to enter some information in your communications program so
that you can connect to CCN. Your communications software
may refer to this information as Communications Settings or Terminal
Settings.
Almost all communications programs allow you to save this information so
you do not have to enter it again.
Now give your software the command to dial, using the settings you saved
in the previous step.
If you get a busy signal, try again later.
If you do not get a "Connect" message or a busy signal, there is a
problem with your modem or with the communications settings in your
software. Check your connections, make sure that the settings match
those listed above, and try again.
Once you are connected
When you have connected to CCN you will be asked for some
important information before you can begin
your session.
If you do not get a "Connect" message or a busy signal, there is a
problem with your modem or with the communications settings in your
software. Check your connections, make sure that the settings match
those recommended.
See also:
![[PayPal]](https://www.chebucto.ns.ca/Icons/paypal2.gif){kind=icon}
